How to setup SECURITY/3000 to receive logons from MINISOFT's ODBC? 

*NOTE* Minimum VESOFT version should be V29.00420.

From the SECURITY/3000 side: 

1. ODBC logons *must* include a HPJOBNAME (sessionname) as part of the logonID; e.g. JOE,ODBC.DEMO. This logonID can optionally have a SECURITY/3000 password. To add this type of logon to the SECURITY/3000 database, from MPEX, enter the following:
     
   %SEC ADD JOE,ODBC.DEMO;YESPASS;VEPASS=yourpass
     

2. Edit the HELLO.DATA.VESOFT file $CONFIG section to include:
     
   $CONFIG NETWORK CHECK @,@.@,@
     

3. Turn on VESOFT's HELLO TRAP:
     
   From MPEX
     
   %BACKG STARTJOB (* If BACKG is *not* running *)
   %BACKG START,HELLO
     

4. Ensure that MINISOFT's listener JCL is running:
     
   :STREAM MSJOB.MM.MINISOFT
     

From MINISOFT's ODBC PC side:

1. Go to ODBC Administrator and select from the DATA SOURCE window MSCARD (HP3000 Data Access Drivers (32 bit)).

2. Click on the SETUP tab, then, click on the CONNECTION tab and enter the appropriate information; i.e. SERVERNAME, SERVERPORT, LOGIN Info; USER, ACCOUNT, GROUP, *JOB NAME* and MPE passwords, if any.

3. Next, click on the SECURITY tab and enter the SECURITY/3000 password, if any, then, click on the OK tab to accept.
     
   **NOTE** Of course, if the SECURITY/3000 password changes on the HP e3000 side; e.g. due to obsolescence or with

   %SEC CHANGE userset;YESPASS;VEPASS=1,yourpass

   the SECURITY tab should also reflect the change to *yourpass*.

   H) Finally, from the SHORTCUT TO ODBC ICON, click on it and try the
   newly added ODBC logon.

    

VESOFT Technical Support
Fax #1.310.785.9566
Ph #1.310.282.0420